AP - Mode

  • How can I connect to a Shelly in AccessPoint mode?

    After applying the supply voltage, a new Shelly automatically starts in AccessPoint mode.



    To connect, proceed as follows:



    1. make new Shelly (if necessary) tensionless
    2. after a short wait Shelly turn on again
    3. Click on the WLAN symbol at the bottom of the taskbar on the computer
    4. there click on the then visible network "Shelly-12346" (numbers are different) and connect
    5. start browser
    6. call address 192.168.33.1


    I wish you success.

Share