the device has an specific ID EG 123456 (short) or idk 123456789 (long)
Some devices can't be updated with the short id
Only for linking if it is short
Posts by SebMai
-
-
had recently been sent one because the user could not update it. For me it went without problems, so check your router first, restart it. If it still doesn't work, check whether he has a long or a short id.
-
No
Have found this in a German Page, please use an translator
Dimmung 0-10 V: Nein Dimmung 1-10 V: Nein Dimmung DALI: Ja Dimmung DMX: Nein Dimmung DSI: Ja Dimmung Potenziometer (geräteintegriert): Nein Dimmung GPRS: Nein Dimmung LineSwitch: Nein Dimmung herstellerspezifisch: Nein Dimmung Netzspannungsmodulation: Nein Dimmung Phasenabschnitt: Nein Dimmung Phasenanschnitt: Nein Dimmung programmierbar: Nein Dimmung RF: Nein Dimmung Sine Wave Reduction: Nein Dimmung Touch and Dim: Nein Dimmung Zigbee: Nein Dimmung mit Push-button: Ja Dimmung abhängig vom Betriebsgerät: Nein Ohne Dimmfunktion: Nein -
perhaps safed in utc?
-
I'm glad you made it, sometimes it just helps to take a break 🙂👍
-
’m sure they make complete sense to electricians
That's the point, you probably aren't and we (by our law) aren't allowed to give you instructions.
That should be right. But don't know the rest of your installation.
And according to this scheme, it doesn't really matter which com is.
But the arrow points to the switch (above) so this is the com / input.
-
Sunrise / sunset is not directly supported in scenes.
But you can use one as a trigger.
For example the first one (goes on or off with Sunrise / sunset)
When
First RGBW2 turn on
Do
Turn on RGBW2 2,3,4 And so on
-
Then you only have the switched phase and the neutral on the lamp.
You will still have a junction box somewhere.
or you use this variant
Then the switch must always remain on for smart operation
-
Then it is probably not really in the cloud. Please disable the cloud and enable it again.
And yes, your thinking is correct, you should be able to control it from outside.
-
For scenes your devices need to be in the cloud and than you can make a scene like
When
Button is pressed once
Do
Take off shelly kitchen
Take off shelly bathroom
Turn on shelly living room
Screenshot_20210605-014102_Shelly.jpg
-
Cloud enabled?
-
you can use the clicking on scenes as trigger , yes
-
Red + and black -?
-
I just looked and according to the internet is a latsching switch a switch that stays on , the user have to push it again for off.
Right?
-
Why would you want him behind the second switch if, according to your description, there is nothing there, except for corresponding lines?
-
please do same what I said before.
Alternatively. disconnect cloud via WebUi. Briefly delete the device from the app. Add a new one (should appear like this) and then confirm the cloud request with yes.
-
Is cloud enabled?
-
I don't know if it is fixed right now.
But change the button type by input 2 (there is still toggle or?)
-
-
It's from 2.5, I don't know if it's the same with the dimmer, just as an idea.
QuoteThe onboard connector is 1.27mm raster with 1mm diameter holes
