I am using the latest firmware 1.11.7. I have taken switch out of the equation which has made no difference. I have the cable which was originally in the common of the switch now in O and what was in L1 of the switch in L. I believe that wiring is correct. It all works fine but after about one minute I get overheating warning and it switches off. I have tried both trailing edge and leading edge which makes no difference. I am powering 6x60w filament bulbs. Any advice appreciated.
Dimmer 2 overheating
-
- Shelly Dimmer
- davidtja
- Unerledigt
Es gibt 3 Antworten in diesem Thema, welches 1.225 mal aufgerufen wurde. Der letzte Beitrag () ist von davidtja.
-
-
6 bulbs, each 60W, gives 360W! Shelly Dimmer2 is suited for max. 220W (filament bulbs). It must overheat in your installation! Split the bulbs in two groups 180W each, use a second Dimmer 2 and give it a chance!
-
OK thanks I'll remove three and see what happens.
-
Thanks very much- that solved it. I didnt realise such a limit. Appreciated.